Page 1 of 1

Posted: Mar 30, 2005 12:32 AM
by Duke
Image

Image

Image

Image

Image

Please disregard the rust on the diff. I figure I must have rust somewhere on the car for posterity.

The TCD 3" exhaust went on easily and fits perfect. I just need to do some tweaking of the exhaust and it is finished. I also need access to a welder to attach the very nice tip I have. Some minor details are left and then the TEC3 will be installed. Then I will start her. I can't believe that it is finally coming to and end. Man, what a project.



[Edit by Duke M535Ti on [TIME]1112160888[/TIME]]

Posted: Mar 30, 2005 2:40 AM
by Monotalonawd
What kind of muffler is that? Straight-tru? We need an exhaust sound clip of it! :D

Posted: Mar 30, 2005 2:48 AM
by Duke
It a Magnaflow. Me no how, sound clip.

Posted: Mar 30, 2005 10:24 AM
by rundatrack
Congrats...ya seem to almost be completed...

Posted: Mar 30, 2005 10:24 AM
by Jeremy
[QUOTE="Monotalonawd"]What kind of muffler is that? Straight-tru? We need an exhaust sound clip of it! :D [/QUOTE]

I have a few movies of Todd's 535i on the dyno, would that do?

Posted: Mar 30, 2005 11:21 AM
by shifty
Lookin' good, Duke. There is light at the end of the tunnel! :)

Posted: Mar 30, 2005 11:57 PM
by Monotalonawd
[QUOTE="Jeremy"]I have a few movies of Todd's 535i on the dyno, would that do?[/QUOTE]

Yes, a link would be appreciated! :)

Posted: Mar 31, 2005 12:51 AM
by RobbieR
Hey! Where's the leather? :D

Posted: Apr 05, 2005 1:02 AM
by dasMafia
you people and catalytic converters..... :D:D:D

Posted: Apr 05, 2005 3:51 PM
by doug
Duke-

Did you just use the stock euro muffler clamp ... bend-to-fit? I can't quite tell from the picture.

Posted: Apr 06, 2005 2:12 AM
by Duke
[QUOTE="dotrp"]Duke-

Did you just use the stock euro muffler clamp ... bend-to-fit? I can't quite tell from the picture.[/QUOTE]

Yep, work out alot better than makeing one for the rear. I have to do some trimming of the bracket but it worked very well.